The stirrup is attached by an electric pulse with a solder wafer between stirrup and the ashtray. If you get a welder to re-attach it you will have color distortion from the heat. I would look into a 2 part epoxy that is made for stainless steel. You want to check the temp rating of the epoxy so...
Get any of the Casa Fuente house cigars. My personal favorite is the Corona Gorda:tu
Everything else is 2 to 3 times more then you can buy it anywhere else. They do have a few HTF's but at a premium:tg
It takes months before you see any mold and then it does start it will just be small dots on the edges of some of the watersorb. I usuall just pick out the ones with mold and keep the rest. If you use PG it will eliminate the problem.
I have begun using a Cigar Oasis to control humidity in the...
I wiped mine down with warm water only, no real strong plastic smell. I also added SP Cedar shelves to give it a nice humidor smell.
It works great. I move my cigars out of the cooler to a humidor for a day or 2 before I smoke them and they smoke great.
I know in Ca. cigarettes have a tax stamp on each pack and the FTB has always been hot on finding un-stamped packages.
But cigars don't have a tax stamp so it appeared to me that cigars did not fall under the same tax law.
This is just my opinion and not to be confused with actual knowledge
I have one and it works very well.
Here is what I have done to keep the temp in check and it ran me about $350.00
It is a wine cooler and here is the break down:
Avanti model EWC28 thermoelectric ( only type to get for better RH control) I got it off ebay from anythingforsale it is a scratch...
The scratch and dent model sold on eBay is from Compact Appliance. As I have stated in a earlier post for a $169.00 delivered it is a good price. Just go through the adv. and read what the damage is. Mine had small dents to the lt. rear corner, that was very minor and didn't effect the...
So you don't actually use the Oasis huh?
Yes I remove the Oasis due to the large amount of condensation I was getting with it in.
.
As for the Watersorb I didn't see much information on their website about the material and what it does. Will it release water as well as absorb it similar to...
Here is what I have done to keep the temp in check and it ran me about $350.00
It is a wine cooler and here is the break down:
Avanti model EWC28 thermoelectric ( only type to get for better RH control) I got it off ebay from anythingforsale it is a scratch & dent model with only small dents...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.